The radio control module and the radio antenna module cannot be replaced individually.

1. Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
2. Disconnect the electrical connector (2) attached to the rear quarter glass panel.
3. Remove the module (1) bolt.



4. Remove the control module (1) from the roof.



5. Remove the cable (2, 3) from the roof cross member by removing the cable clips (1).



6. Disconnect the electrical connector (2) attached to the rear quarter glass panel (1).
7. Remove the module (3) bolt.
8. Remove the antenna module from the roof.
9. Remove the radio control modules and cable from the vehicle.

1. Install the antenna module (3) to the roof.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the module bolt.

Tighten
Tighten the bolt to 9 N·m (80 lb in).

3. Connect the antenna cable to the module (3), if disconnected.
4. Connect the connector (2) to the rear quarter glass panel (1).



5. Install the cable (2, 3) to the roof cross member by pushing in the retainer clips (1).



6. Install the module bolt.

Tighten
Tighten the bolt to 9 N·m (80 lb in).

7. Connect the antenna cable to the module (1).
8. Connect the connector (2) to the rear quarter glass panel (3).
9. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.