Step | Action | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Interior Lights Dimming Schematics or Body Control System Schematics in Computer/Integrating Systems Connector End View Reference: Lighting Systems Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems | |||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information | ||||||
2 | Verify that the interior backlighting is inoperative. Does the interior backlighting operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 | ||||||
3 | Are all of the interior backlighting lamps inoperative? | Go to Step 5 | Go to Step 4 | ||||||
4 | Test for an open or high resistance in the following circuits of the inoperative lamp. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct a condition? | Go to Step 13 | Go to Step 8 | ||||||
5 | Is the TBC 2A Fuse in the instrument panel (I/P) fuse block open? | Go to Step 6 | Go to Step 7 | ||||||
6 | Test the battery positive voltage circuit of the body control module (BCM) for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 13 | Go to Step 10 | ||||||
7 | Test for the following conditions. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition? | Go to Step 13 | Go to Step 9 | ||||||
8 | Inspect for poor connections at the harness connector of the affected lamp. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 13 | Go to Step 11 | ||||||
9 | Inspect for poor connections at the harness connector of the body control module. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 13 | Go to Step 12 | ||||||
10 | Repair the controls illumination lamps dimming control circuit for a short to ground. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 13 | -- | ||||||
11 | Replace the affected lamp or internal lamp component. Did you complete the replacement? | Go to Step 13 | -- | ||||||
12 | Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 13 | -- | ||||||
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 | ||||||
