For 1990-2009 cars only
Removal Procedure
- Remove all retaining screws.
- Grasp the lower part of the molding.
- Pull outwards to release the clips from the body panel.
Important: When any molding is removed, all retaining clips needs to be replaced with new ones if the molding is to be reused.
Installation Procedure
- Use a 3M™ scotch brite molding adhesive remover disk P/N 07501 or equivalent to remove any adhesive tape on the body panel.
- Peel off the adhesive tape protective lining.
- Align the retaining clips in their respective holes.
- Press firmly on the molding until all the retaining clips are fully seated.
- Press on the top part of the molding so that the tape adheres to the body panel.
