GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 Escalade ESV 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Transfer Case Shift Control Switch Inoperative

Circuit Description

The mode switch circuit consists of the following four switches:

    • 4LO
    • All wheel drive (AWD)
    • Neutral
    • Traction control system (TCS)

The transfer case shift control module supplies a regulated 5 volts DC to the switch through the 5 volt reference circuit. The current travels through the resistor of the currently active switch. The switch then returns the current to the transfer case shift control module through the switch signal circuit.

The transfer case shift control module constantly monitors this signal voltage to determine the condition of the mode switch circuit.

When each switch is depressed, the switch completes a circuit through the respective resistor. The transfer case shift control module continuously monitors the switch input to determine which of the following buttons is selected by the driver:

    • 4LO
    • AWD
    • Neutral
    • TCS

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step tests the functionality of the mode switch.

    2.

  2. This step tests the modules ability to operate the transfer case modes.

Step

Action

Yes

No

Schematic Reference: Transfer Case Control Schematics

Connector End View Reference: Transfer Case Control Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2
  1. Install a scan tool.
  2. Start the engine.
  3. Place the transmission into Neutral.
  4. Set the parking brake.
  5. Use the scan tool in order to observe the Commanded Mode Indicator parameter while selecting each of the mode positions.

Does the state change with each selection of the mode positions?

Go to Step 5

Go to Step 3

3
  1. Use a scan tool in order to command through each mode of the mode selection switch.
  2. With a scan tool, command through all Commanded Mode Indicator parameter states.

Does the Mode Indicator state change?

Go to Step 4

Go to Step 5

4

Replace the mode selection switch. Refer to Transfer Case Shift Control Switch Replacement .

Did you complete the repair?

Go to Step 6

--

5

Replace the transfer case shift control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle in order to determine if the symptom has been corrected.

Is the symptom still present?

Go to Step 2

System OK