GM Service Manual Online
For 1990-2009 cars only

Special Tools

    • J 2619-01 Slide Hammer
    • J 8092 Driver Handle
    • J 21128 Axle Pinion Oil Seal Installer
    • J 23690 Bearing Installer
    • J 45857 Tone Wheel and/or Bearing Remover
    • J 45860 Tone Ring Installer

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement.
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement.
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement.

  6. Object Number: 889095  Size: SH
  7. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J 45857  (1) and the J 2619-01  (2).

Installation Procedure


    Object Number: 885621  Size: SH
  1. Install the wheel speed sensor ring using the J 45860  (1) and the J 8092  (2).
  2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.

  3. Object Number: 695758  Size: SH
  4. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  5. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.

  6. Object Number: 885624  Size: SH
  7. Install the axle shaft seal using the J 21128 .
  8. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  9. Install the axle shaft. Refer to Rear Axle Shaft Replacement.
  10. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement.
  11. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement.
  12. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  13. Fill the rear axle. Refer to Rear Axle Lubricant Replacement.
  14. Lower the vehicle.