The fuel pump flow control module (FPCM) monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.

The engine is running.

The FPCM detects that the IGN voltage is less than 6.0 volts.

DTC P2534 is an A type DTC.

DTC P2534 is an A type DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Fuel System Description

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Verify that DTC P0562 is not set.

⇒	If DTC P0562 is set, refer to DTC P0562.

2. Ignition OFF, disconnect the harness connector at the FPCM.
3. Ignition ON, test for greater than 11 volts between the voltage circuit terminal 15 and ground.

⇒	If less than the specified voltage, test the voltage circuit for a short to ground or an open/high resistance. If the circuit test normal and the circuit fuse is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the RUN/CRANK relay.

4. If all circuits test normal, replace the FPCM.

Relay Test

1. Ignition OFF, disconnect the RUN/CRANK relay.
2. Test for 60-180 ohms between terminals 85 and 86.

⇒	If the resistance is not within the specified range, replace the relay.

3. Test for infinite resistance between the following terminals:

•

30 and 86

•

30 and 87

•

30 and 85

•

85 and 87

⇒	If less than infinite resistance, replace the RUN/CRANK relay.

4. Install a 20-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2.0 ohms between terminals 30 and 87.

⇒	If greater than 2.0 ohms, replace the RUN/CRANK relay.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.