Preliminary Procedures

1. Deploy the power assist step.
2. Disconnect any electrical connectors.

1

Assist Step Motor Wedge Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
8 N·m (71 lb in)

2

Assist Step Motor Wedge

3

Assist Step Motor Bolts (Qty: 3)

Tighten
12 N·m (9 lb ft)

4

Assist Step Motor

Important: Make sure the flat on the motor is parallel to the floor before installing. All new motors should be shipped with motor flat in the correct position. As the motor is installed shake the board up and down gently to make sure the wedge and flat seat together correctly or unwanted noise could result.

Tip
Once the installation of the new motor is completed the assist step must be cycled once for the module to learn the positioning.