GM Service Manual Online
For 1990-2009 cars only

Service of the powertrain control module (PCM) should normally consist of either replacement of the PCM or electrically erasable programmable read only memory (EEPROM) programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first to see if the correct part is being used. If the correct part is being used, remove the faulty PCM and install the new service PCM.

       Important: To prevent internal PCM damage, the ignition must be OFF when disconnecting or reconnecting power to the PCM. For example, when working with a battery cable, PCM pigtail, PCM fuse, or jumper cables.

    • Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing or replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the PCM.
    • The replacement PCM must be programmed.

Removal Procedure

    Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100%. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.

  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.

  2. Object Number: 334905  Size: MH
  3. Release the PCM cover mounting holes (1,5) away from the mounting tabs on the PCM mounting bracket.
  4. Release the PCM cover (8) from the mounting bracket.
  5. Remove the PCM cover.
  6. Notice: Do not touch the connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage to the PCM.

    Notice: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

  7. Disconnect the PCM harness connectors (6).
  8. Release the spring latch (2) from the PCM.
  9. Release the PCM mounting tabs (3) from the PCM.
  10. Remove the PCM (4) from the engine compartment.

Installation Procedure


    Object Number: 334905  Size: MH
  1. Install the PCM (4) to the PCM mounting bracket (7) ensuring that the mounting tabs (3) are engaged.
  2. Secure the spring latch (2) to the PCM.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Connect the PCM connectors (6) to the PCM (4).
  5. Tighten
    Tighten the PCM connector end fasteners to 8 N·m (71 lb in).

  6. Install the PCM cover (8) to the PCM mounting bracket (7), ensuring the mounting tabs on the PCM mounting bracket are engaged into the mounting holes in the PCM cover.
  7. If a new PCM is being installed, program the PCM. Refer to Powertrain Control Module Programming .