GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 DeVille 🢒 Body 🢒 Doors 🢒 Rear Electrical Center or Junction Block Replacement

Removal Procedure
  1. Disconnect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

    2. Object Number: 471716 Size: SH
  2. Remove the rear fuse block cover.
  3. Remove the positive battery cable fastener (1) from the battery cable.
  4. Remove the positive battery cable from the rear fuse block.
  5. Unclip the four retaining clips, lift the electrical fuse block up and turn over.
  6. Remove the three connector fasteners and remove all the connectors from the fuse block.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install all the connectors to the rear fuse block and hand start the fasteners.

    2. Tighten
    Tighten the fasteners to 6 N·m (53 lb in).


    Object Number: 471716 Size: SH
  2. Install the rear fuse block into the base assembly ensuring all the clips engage.
  3. Install the positive battery cable and fastener (1) to the rear fuse block.

    4. Tighten
    Tighten the fastener to 15 N·m (11 lb ft).

  4. Connect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.