GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling in Restraints.

  2. Object Number: 589845  Size: SH
  3. Remove the passenger side rear assist handle. Refer to Assist Handle Replacement.

  4. Object Number: 106069  Size: SH
  5. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement.

  6. Object Number: 106073  Size: SH
  7. Remove the rear seat back. Refer to Rear Seat Back Replacement.

  8. Object Number: 474797  Size: SH
  9. Remove the rear passenger seat belt retractor (4). Refer to Rear Seat Belt Retractor Replacement.

  10. Object Number: 106197  Size: SH
  11. Remove the passenger side rear sail panel. Refer to Sail Panel Replacement.

  12. Object Number: 493161  Size: SH

    Important: Release the passenger side center pillar trim garnish molding upper retainer.

  13. Carefully pull the upper center trim panel inward in order to allow clearance for the headliner.
  14. Carefully pull the passenger side of the headliner downward in order to release the center and rearward headliner roof magnets.

  15. Object Number: 468359  Size: SH
  16. Reach inward between the headliner and roof panel in order to release the sunroof control module clip (3) securing the control module (1) to the sunroof module assembly (2).
  17. With the clip (3) depressed, slide the control module toward the sunroof motor/actuator.

  18. Object Number: 107180  Size: SH
  19. Disconnect the electrical connectors.
  20. Remove the sunroof control module from the vehicle.

Installation Procedure


    Object Number: 107180  Size: SH
  1. Connect the electrical connectors to the sunroof control module.

  2. Object Number: 468361  Size: SH
  3. Install the sunroof control module tabs (2) into the slots (3) located on the sunroof module assembly.
  4. Slide the sunroof control module (1) away from the sunroof motor/actuator until the sunroof control module is fully engaged to the sunroof module assembly.
  5. Important: Test the proper operation of the sunroof functions before installing the interior trim components.

  6. Reposition the headliner to the center and rearward roof magnets.

  7. Object Number: 106197  Size: SH
  8. Install the passenger side sail panel. Refer to Sail Panel Replacement.

  9. Object Number: 474797  Size: SH
  10. Install the passenger side rear seat belt retractor (4). Refer to Rear Seat Belt Retractor Replacement.

  11. Object Number: 106073  Size: SH
  12. Install the rear seat back. Refer to Rear Seat Back Replacement.

  13. Object Number: 106069  Size: SH
  14. Install the rear seat cushion. Refer to Rear Seat Cushion Replacement.

  15. Object Number: 493161  Size: SH
  16. Align the upper center trim panel retainer, push inward in order to secure.
  17. Reposition the passenger rear door opening weatherstrip seal.

  18. Object Number: 295014  Size: SH
  19. Install the passenger side rear assist handle. Refer to Assist Handle Replacement.
  20. Enable the SIR system. Refer to SIR Disabling and Enabling.
  21. Close the passenger rear door.
  22. Refer to Control Module References for programming and setup information.