GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 155410  Size: SH
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
  2. Caution: Wear safety glasses when using compressed air in order to prevent eye injury.

  3. Blow dirt out of the fitting using compressed air.

  4. Object Number: 12777  Size: SH
  5. Squeeze the plastic tabs of the male end connector.

  6. Object Number: 12778  Size: SH
  7. Pull the connection apart.
  8. Notice: Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface.

  9. Wipe off the male pipe end using a clean shop towel.
  10. Inspect both ends of the fitting for dirt and burrs.
  11. Clean or replace the components as required.

Installation Procedure

Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

This will ensure proper reconnection and prevent a possible fuel leak.

During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.


    Object Number: 155425  Size: SH
  1. Apply a few drops of clean engine oil to the male pipe end.

  2. Object Number: 155771  Size: SH
  3. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.

  4. Object Number: 155399  Size: SH
  5. Pull on both sides of the quick connect fitting in order to make sure the connection is secure.