Removal Procedure
- Remove the idle air control (IAC) electrical connector (1) from
the IAC sensor (4).
- Remove the manifold absolute pressure (MAP) sensor electrical
connector from the MAP sensor.
- Remove the water pump belt cover.
- Remove the TP sensor retaining screws electrical connector (2)
from the TP sensor (3).
- Remove the TP sensor electrical connector (2) from the
TP sensor (3).
Installation Procedure
- Install the new O-ring
on to the TP sensor.
- Connect the TP Sensor electrical connector (2) to the TP
sensor (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the TP sensor (2)
on to the throttle body (1).
Tighten
Tighten the TP sensor screws to 2.3 N·m (20 lb in).
- Connect the IAC electrical connector (1) to the IAC sensor (4).
- Connect the MAP sensor electrical connector to the MAP sensor.
- Install the water pump belt and tensioner cover.
- Perform the TP Sensor learn procedure:
| 7.1. | Turn the ignition to the RUN/ON position. |
| 7.3. | Turn the ignition to the LOCK/OFF position. |
