Driver Knee Bolster Replacement Without UV2

Important: The knee bolster trim panel (1) must be replaced, not repaired, if there is any visible damage.

1. Remove the knee bolster trim panel (1) by grasping at the top and the bottom and by pulling rearward.
2. Remove the knee bolster trim (1) from the vehicle.

1. Align the knee bolster trim (1) guide pins to the IP.
2. Push forward firmly in order to engage the clips to the IP retainer.

Driver Knee Bolster Replacement UV2

Important: The knee bolster trim panel must be replaced, not repaired, if there is any visible damage.

1. Remove the knee bolster trim panel by grasping at the top and the bottom and by pulling rearward.
2. Disconnect the night vision switch electrical connector (2).
3. Remove the knee bolster trim from the vehicle.

1. Connect the night vision switch electrical connector (2).



2. Align the knee bolster trim guide pins to the lower IP.
3. Push forward firmly in order to engage the clips onto the IP retainer.