Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
- Remove the multifunction switch retaining screws.
- Disconnect the multifunction switch electrical connections.
- Remove the multifunction switch.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Connect the multifunction switch electrical connectors.
- Install the multifunction switch to the steering column.
- Install the multifunction switch retaining screws.
- Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the multifunction switch retaining screws to 7 N·m
(62 lb in).
