Rear Seat Back Cushion Latch Cable Replacement 1st Design

1. Remove the rear seat back and disconnect the rear seat back pass through release cable (1). Refer to Rear Seat Back Replacement in Seats.
2. Remove the tie strap securing the rear seat pass thorough release cable (1) to the seat back.
3. Remove the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.



4. Remove the nut (1) from the seat pass thorough release handle.



5. Remove the seat pass thorough release cable (2) and handle from the electrical component mounting panel (1).



6. Remove the cable housing (1) from the release handle housing (2) and slide the cable out of the lever in the handle.
7. Remove the release handle from the cable (1).

1. Install the seat pass thorough release cable (1) to the slot in the lever on the release handle (2).



2. Snap the cable housing to the release cable handle housing.



3. Install the pass thorough release cable (2) and handle through the opening in the electrical component mounting panel (1).



4. Partially Install the rear seat back.
5. Connect the rear seat back pass through release cable (1).
6. Tie strap the pass through release cable (1) to the seat frame.



7. Install the rear seat back. Refer to in Seats.
8. Install the release handle to the body.
9. Install the release handle nut (1).

Tighten
Tighten the nut to 9N·m (80 lb in).

10. Install the rear trunk trim. Refer to in Body Rear End.

Rear Seat Back Cushion Latch Cable Replacement 2nd Design

1. Remove the rear seat back and disconnect the rear seat back release cable (1). Refer to Rear Seat Back Replacement in Seats.
2. Remove the tie strap securing the rear seat pass thorough release cable.
3. Remove the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.



4. Remove the nut (1) from the seat pass thorough release handle.



5. Remove the seat pass thorough release cable (2) and handle from the electrical component mounting panel (1).



6. Remove the cable housing (1) from the release handle housing (2) and slide the cable out of the lever in the handle.
7. Remove the release handle from the cable (1).

1. Install the seat pass thorough release cable (1) to the slot in the lever on the release handle (2).



2. Snap the cable housing to the release cable handle housing.



3. Install the pass thorough release cable (2) and handle through the opening in the electrical component mounting panel (1).



4. Partially Install the rear seat back.
5. Connect the rear seat back pass through release cable (1).

Notice: Refer to Fastener Notice in the Preface section.

6. Install the pass through release cable screw (2).

Tighten
Tighten the nut to 2N·m (18 lb in).

7. Tie strap the pass through release cable (1) to the seat frame.



8. Install the rear seat back. Refer to Rear Seat Back Replacement in Seats.
9. Install the release handle to the body.
10. Install the release handle nut (1).

Tighten
Tighten the nut to 9N·m (80 lb in).

11. Install the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.