Schematic Reference: HVAC Schematics

Connector End View Reference: HVAC Connector End Views

DEFINITION: Air recirculation is inoperative or always on.

Did you perform the HVAC Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - HVAC Systems - Automatic

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Recalibrate the motors. Refer to Actuator Recalibration .
4. With a scan tool, observe the current DTC list in Instrument Panel Module.

Does the scan tool display any DTCs?

--

Go to Diagnostic Trouble Code (DTC) List

Go to Step 3

1. Place the blower motor switch in the maximum speed position.
2. Place the mode switch in the bi-level position.
3. Alternately, place the recirculation switch in the recirculation and outside air positions.

Does the recirculation door move from the recirculation position to the ambient air position?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Go to Step 4

1. With a scan tool, observe the Air Inlet Dr. Commanded parameter in the Instrument Panel Module data list.
2. Alternately place the recirculation switch in the recirculation and outside air positions.

Does the scan tool indicate that the value of the Air Inlet Dr. Commanded parameter changes from the minimum specified value to the maximum specified value?

0-230 counts

Go to Step 6

Go to Step 5

Inspect for poor connections at the harness connector of the HVAC control module (IPM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 7

Inspect and the air distribution system for the following conditions:

1. A restricted passenger compartment air filter.
2. An obstruction restricting air flow.
3. Air leaks.
4. Misaligned ducts.

Did you find and correct the condition?

--

Go to Step 8

--

Important: Perform the recalibration procedure for the IPM.

Replace the IPM. Refer to HVAC Control Module Replacement .

Did you complete the replacement?

--

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3