Tools Required
J 44298 Drivers
Air Bag Removal Tool
Removal Procedure
Caution: When you are carrying an undeployed inflator module:
• | Do not carry the inflator module by the wires or connector on
the inflator module |
• | Make sure the bag opening points away from you |
When you are storing an undeployed inflator module, make sure the bag
opening points away from the surface on which the inflator module rests.
When you are storing a steering column, do not rest the column with the bag
opening facing down and the column vertical. Provide free space for the
air bag to expand in case of an accidental deployment. Otherwise, personal
injury may result.
- Disable the SIR system.
Refer to
Disabling the SIR System
.
- On the back side of the steering wheel are 4 openings for
removing the driver inflator module.
- Position the steering wheel so that 2 of the openings are
at the top.
- Adjust and install J 44298
into the 2 holes.
Important: Seat the air bag removal tool fully in the openings.
- Push the handle back towards I/P, releasing the 2 spring-loaded
retainers at the same time.
- Position the steering wheel in order to access the 2 remaining
openings at the top.
- Push the handle back towards the I/P in order to release the 2
remaining spring-loaded retainers at the same time.
- Pull the driver inflator module gently away from the steering
wheel.
Important: Note the driver inflator wire routing positions and the horn wire routing
positions for the correct re-assembly.
- Remove the connector position assurance (CPA) from the electrical connector.
- Disconnect the electrical connector (4) from the driver
inflator module.
- Disconnect the horn electrical connector (2).
- Remove the steering wheel module (5).
- Fully deploy the module before disposal. If the module was replaced
under warranty, fully deploy and dispose of the module after the required
retention period. Refer to
Inflator Module Handling, Shipping, and Scrapping
.
Installation Procedure
- Connect the horn electrical connector (2).
- Connect the inflator module electrical connector (4). Install
the CPA to the driver inflator module electrical connector.
Important: Route the driver inflator wires and the horn wires correctly.
- Align the driver inflator module retainers to the steering wheel.
- Push the driver inflator module (5) firmly to the steering
wheel in order to engage the drivers inflator retainers.
- Enable the SIR system. Refer to
Enabling the SIR System
.