At the rear shock absorbers, the air tube connectors are held on with spring clips which snap into the grooves of the shock absorber air fittings. Air tube connectors are sealed using two O-rings.
Important:
• Before disconnecting any air tube, clean the connector and the
surrounding area to prevent dirt and other foreign material from entering
the ELC system. • To disconnect an air tube from a shock absorber, rotate the spring
clip 90 degrees out of the slots, and pull the connector from the shock absorber. • Ensure that the air tube is routed correctly and all fasteners
are used. • To connect an air tube to a shock absorber, lubricate the two
O-rings using silicone lubricant, rotate the spring clip 90 degrees into the
slots, and push the air tube connector on the shock absorber fitting until
spring clip snaps into fitting groove.
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the air tube from the air dryer.
- Remove the bolt and the harness tie from the air compressor bracket.
- Remove both rear wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Disconnect the air tube from the left and right rear shock absorbers.
- Remove the 2 metal clips from the air tube and the vehicle.
- Remove the air tube with the 3 clips from the vehicle.
Installation Procedure
- Connect the air tube to the air dryer.
- Install the air tube with the harness tie and the bolt on the air compressor bracket.
- Install the air tube on the vehicle with 3 clips.
- Connect the air tube to the left and right rear shock absorbers.
- Install 2 metal clips on the air tube and the vehicle. Place each clip immediately forward of the wheel house fold-over tabs on the LH and RH side of the vehicle.
- Install both rear wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.
