Parking Brake Rear Cable Replacement - Left Side JL9

1. Release the park brake.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .



4. Remove the front brake cable (1) from the connector (2).




Important: If the equalizer (1) is damaged, replace the equalizer.

5. Remove the left rear brake cable (3) from the equalizer (1).



6. Using the J 37043 , remove the left park brake cable (1) from the retaining bracket (2).



7. Remove the left park brake cable from the retainer (1).



8. Remove the left rear brake cable from the retainer (1).
9. Remove the left rear brake cable retaining bolt (2).




Important: Right rear brake caliper shown, left similar.

10. Slide the park brake cable (1) forward and remove it from the park brake actuator lever (2).
11. Remove the park brake cable (1) from the caliper (3).

1. Install the park brake cable (1) into the bracket on the brake caliper (3).
2. Slide the park brake cable forward and install to the park brake actuator lever (2).

Notice: Refer to Fastener Notice in the Preface section.




3. Install the retaining bolt (2).

Tighten
Tighten the retaining bolt to 6 N·m (53 lb in).

4. Install the retaining clip (1).



5. Install the left rear brake cable in the retainer (1).



6. Install the left rear brake cable (1) in the retaining bracket (2).



7. Install the left rear brake cable (3)  to the equalizer (1).



8. Install the front brake cable (1) in the connector (2).
9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .

Parking Brake Rear Cable Replacement - Left Side J55

Tools Required

J 37043 Parking Brake Cable Release Tool

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Pull down on the intermediate brake cable (4) to relieve the cable tension.
3. Lift up on the rear tab in the connector (3) to remove the intermediate brake cable (4) from the front brake cable (2).



4. Remove the brake cable retaining bolt .



5. Lift up the tab (7) to remove the brake cable (8) from the equalizer (6).



6. Using the J 37043 , remove the brake cable (10) from the mounting bracket (9).
7. Remove the brake cable (10) from the mounting bracket (9).




Important:  In the following service procedure, push the inner brake cable forward to gain enough cable to remove it from the actuator.

8. Remove the brake cable (12) from the actuator (11).
9. Using the J 37043 , remove the brake cable (12)  from the mounting bracket.
10. Remove the brake cable.

Important:  Ensure that the brake cable is properly seated actuator arm.

1. Install the brake cable (12)  in the actuator arm (11).

Important:  Ensure that the brake cable is properly seated in the mounting bracket.

2. Install the brake cable in the mounting bracket.



3. Position the brake cable on the rear control arm.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the retaining bolt in the rear control arm.

Tighten
Tighten the retaining bolt to 24 N·m (18 lb ft).




5. Install the brake cable (10) in the mounting bracket (9).



6. Install the brake cable (8) into the equalizer (6).
7. Bend the lock the tab (7) into the proper position.




Important: In the following service procedures, ensure the locking tabs are properly seated

9. Install the intermediate (4)  and front brake (2)  cables in the connector (3).
10. The park brake system is self-adjusting. No cable adjustment is needed.
11. Lower the vehicle.