Caution: Refer to Brake Dust Caution in the Preface section.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedure

Remove the brake caliper mounting bracket. Refer to Rear Brake Caliper Bracket Replacement.

1

Rotor Retention Bolt

Tighten
12 N·m (106 lb in)

2

Brake Rotor

Tip

1. If removing the rotor to service the wheel bearing/hub, use the J 41013 , to clean the contact area of the rotor to the wheel bearing/hub.
2. If servicing the rotor, use the J 42450-A , to clean the contact area of the wheel bearing/hub.
3. If the brake rotor was removed and installed measure the lateral runout measurement (LRO). Refer to Brake Rotor Assembled Lateral Runout Measurement.
4. If the LRO measurement exceeds specifications, refer to Brake Rotor Assembled Lateral Runout Correction.
5. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing.

Caution: Refer to Brake Dust Caution in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake caliper mounting bracket. Refer to Rear Brake Caliper Bracket Replacement .

1

Brake Rotor

Tip