Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove the left front inner wheelhouse liner. Refer to Front Wheelhouse Liner Replacement.
4. Thoroughly clean the area around the electronic brake control module (EBCM) of all dirt and debris.

1

Electronic Brake Control Module Bolts (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

After the installation is complete, tighten the bolts in a cross pattern beginning with the upper left bolt.

Tighten
3 N·m (27 lb in)

2

Electronic Brake Control Module

Procedure

1. Clean the sealing surfaces of the EBCM and the brake pressure modulator valve with denatured alcohol and a clean shop cloth.
2. Disconnect the electrical connector from the electronic brake control module.
3. If a new electronic brake control module is installed, program the electronic brake control module. Refer to Service Programming System (SPS).
4. If a new electronic brake control module is installed, program the electronic brake control module. Refer to Control Module References.