Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC U2099 00: High Speed Communication Enable CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
High Speed GMLAN Serial Data Wake Up | U2099, U0100-U0299¹ | U0100-U0299 | U0100-U0299² | -- |
¹ Vehicle will not start. ² History only. If cleared the DTC will return after several ignition cycles. | ||||
Circuit/System Description
The body control module (BCM) applies voltage to the high speed GMLAN serial data wake up circuit, when the ignition key is in ACC, ON or START to enable several modules for bus communication.
Depending on option content, modules that may receive the signal are as follows:
| • | Electronic brake control module (EBCM) |
| • | Electronic suspension control (ESC) module - (FE1) (F38) (F55) |
| • | Distance sensing cruise control (DSCC) module - (K59) |
Conditions for Running the DTC
| • | The system voltage is between 9-16 volts. |
| • | The BCM attempts to enable the modules connected to the high speed GMLAN serial data wake up circuit. |
Conditions for Setting the DTC
The BCM senses a short to ground on the high speed GMLAN serial data wake up circuit.
Action Taken When the DTC Sets
| • | The output command is turned off while the malfunction is present. |
| • | The modules use a default value for the missing parameters. |
| • | The module(s) is never signaled, therefore the specific subsystem(s) will not function. |
| • | The vehicle will not start while the circuit is shorted to ground. |
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction. |
Diagnostic Aids
| • | Use the DMM MIN/MAX function to capture/locate intermittent conditions. |
| • | Short to ground will also set multiple history no communication codes for GMLAN high speed modules |
Reference Information
Schematic Reference
Connector End View Reference
Data Communication Connector End Views
Description and Operation
Data Link Communications Description and Operation
Electrical Information Reference
Circuit/System Testing
- With the ignition OFF, disconnect the harness connector at the EBCM, ESC module, and DSCC module one at a time . After each disconnect, retest for current DTCs. DTC U2099 should remain current.
- Ignition OFF, disconnect the harness connector at the BCM.
- With all modules disconnected, test for infinite resistance between the high speed GMLAN serial data wake up circuit and ground.
- If all tests normal and DTC is current, replace the BCM.
| ⇒ | If the DTC becomes history, replace the module disconnected before the DTC became history. |
| ⇒ | If less than infinite resistance, repair the wake up circuit for a short to ground. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for module replacement, setup, and programming
