GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 293350  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement .
  3. Rotate the stabilizer shaft downward.
  4. Remove the electrical harness clip from the power steering gear heat shield.
  5. Remove power steering gear heat shield mounting bolts.
  6. Remove the power steering gear heat shield.

Installation Procedure


    Object Number: 293350  Size: SH
  1. Install the power steering gear heat shield.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the power steering gear heat shield mounting bolts.
  4. Tighten
    Tighten the power steering gear heat shield mounting bolts to 9 N·m (79 lb in).

  5. Install the electrical harness clip to the power steering gear heat shield.
  6. Rotate the stabilizer shaft into position.
  7. Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement .
  8. Lower the vehicle.