Preliminary Procedures

1. Remove the ignition and start switch. Refer to Ignition and Start Switch Replacement .
2. If equipped with AN3, disconnect the park lock cable. Refer to Transmission Control Replacement .
3. Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
4. Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .

1

Ignition Lock Cylinder Case Bolt (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
7 N·m (62 lb in)

2

Ignition Lock Cylinder Case