Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Remove the knee bolster panel. Refer to Driver Knee Bolster Replacement .
2. Disconnect the electrical connector from the brake pedal position sensor.

1

Nut (Qty: 2)

Tighten
10 N·m (89 lb in)

2

Accelerator Pedal

Tip

3

Clip

4

Spacer

Tip
Apply silicone brake lubricant to the brake pedal pushrod pivot pin.

5

Nut (Qty: 4)

Tip

1. Lower the steering column. Refer to Steering Column Replacement .
2. You DO NOT have to remove the steering column from the vehicle. Lower the steering column to gain access to the mounting bolts for the brake pedal mounting bracket.

Tighten
30 N·m (22 lb ft)

6

Brake Pedal

Tip
Re-calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .