For 1990-2009 cars only
- Install the secondary pump gears (205, 206) into the secondary pump body (203).
- Install the primary pump gears (201, 202) into the primary pump body (200).
- Inspect the pump gears (201, 202, 205, 206). These gears must be installed with the dimples facing up.
- Install the scavenge pump cover (237) onto the primary pump body (200) over the dowel bushings (227). Tap the dowels in place to that they stick out of both the primary pump body and the scavenge cover.
- Install the scavenge pump cover and primary body assembly (200/237) onto the secondary pump body (203). Press the entire assembly firmly together.
- Install the oil pump driven shaft (207) into the pump assembly. The end of the shaft with the four notches is located in the secondary pump.
- Install the scavenge pump drive gear (223) over the pump driven shaft.
- Align the scavenge pump driven gears (224) next to the drive gear (223). Install the scavenge pump body (225) onto the scavenge pump cover. Locate the scavenge pump driven gear pins into the scavenge pump driven gears (224). Press firmly into position.
- Install the two 10-mm bolts (226) through the scavenge pump cover (237) to the scavenge pump body (225).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 11-13 N·m (8.0-9.5 lb ft).
