WINDSHIELD WIPER CHATTER AND WIPEABILITY SERVICE PROCEDURE

SUBJECT: WINDSHIELD WIPER BLADE CHATTER/WIPEABILITY CONCERNS CAUSED BY CHANGE IN BLADE ANGLE (INSTALL SPACER)

MODELS AFFECTED: 1982-1988 CIMARRONS

Some 1982-1988 Cimarrons may experience a condition of driver side blade chatter and wipeability concerns. This condition may be caused by wiper housing mounting tolerances that change the attack angle of the driver side blade assembly.

IMPORTANT: Before doing any work, clean windshield and both blades with GM windshield cleaner, P/N 1050011, or equivalent. Then recheck wiper-washer operation. If problems persist after cleaning, follow the procedures in this bulletin.

To repair this condition install spacer, P/N 22111290, over driver side linkage housing. Refer to Figure 1. Make sure spacer is correctly oriented. Parts are currently available at GMSPO.

Finger tighten the new screws provided, then tighten evenly to 8 N.m (70 lbs. in.).

NOTE: When reassembling cowl, make sure that washer hose is reconnected (and not pinched).

If an interference condition results between the wiper arm head casting and the cowl clearance hole, use a file to enlarge hole at interference point.

For warranty purposes use Labor Operation T4677 at .4 hour.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.