GM Service Manual Online
For 1990-2009 cars only

Jacking Points for Lifting Equipment


Object Number: 279173  Size: LF

Lifting and Jacking Points


Object Number: 623892  Size: MH

Caution: To help avoid personal injury, always use jack stands when you are working on or under any vehicle that is supported only by a jack.

Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

Notice: When you are jacking or lifting a vehicle at the frame side rails or other prescribed lift points, be certain that the lift pads do not contact the catalytic converter, the brake pipes or the fuel lines. If such contact occurs, vehicle damage or unsatisfactory vehicle performance may result.

Before beginning any lifting procedure, be sure the vehicle is on a clean, hard, level surface. Be sure all the lifting equipment meets weight standards and is in good working order. Be sure all the vehicle loads are equally distributed and secure. If the vehicle is only being supported at the frame side rails, make sure the lifting equipment does not put too much stress on or weaken the frame side rails.

If using any other hoisting methods than those called out, take special care not to damage the fuel tanks, the exhaust system or the underbody.

Frame Contact Hoist

Front Hoist Pads


Object Number: 439843  Size: SH

Important: The front hoist pads must not contact the rocker panels, the front fenders, the floor pan, or the stone guard moldings. Remove the jacking covers from the rocker panels if necessary.

Position the (frame contact) front hoist pads as follows:

    • Under the front frame rail reinforcement.
    • The long sides of the pads (if applicable) parallel to the frame rails.

Rear Hoist Pads


Object Number: 439846  Size: SH

Important: The rear hoist pads must not contact the rocker panels, the rear fenders, the floor pan, or the stone guard moldings. Remove the jacking covers from the rocker panels if necessary.

Position the (frame contact) rear hoist pads as follows:

    • Under the rear frame rail at the rear axle cradle mount flange.
    • The long sides of the pads (if applicable) perpendicular to the frame rails.

Floor Jacks

When lifting a vehicle with a floor jack, block the wheels at the opposite end from which the vehicle is being lifted. Use jack stands to provide additional support.

Under the Frame Rail Reinforcements

Important: The floor jack pad must not contact the rocker panels, the floor pan, or the stone guard moldings. Remove the jacking covers from the rocker panels if necessary.

Position the floor jack pad under the front frame rail reinforcement or under the rear frame rail at the rear axle cradle mount flanges.

Under the Engine Front Crossmember Frame


Object Number: 623894  Size: SH

Important: The floor jack pad must not contact the oil pan, splash shield or the steering linkage.

Position the floor jack pad under the center of the engine front crossmember frame.

Jack Stands

Under the Frame Rail Reinforcements

Important: The jack stands must not contact the rocker panels, the floor pan, or the stone guard moldings. Remove the jacking covers from the rocker panels if necessary.

Position the jack stand under the frame rail reinforcements.