Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Wiper/Washer
System Check performed?
| --
| Go to
Step 2
| Go to
Wiper/Washer System Check
|
2
| Check the integrity of the Wiper fuse.
Is the Wiper Fuse open?
| | Go to
Step 8
| Go to
Step 3
|
3
|
- Disconnect the windshield wiper motor connector.
- Turn the ignition switch to the ON position.
- Turn the windshield wiper/washer switch to the HI position.
- Use a DMM in order to measure the voltage between terminal E
of the windshield wiper motor connector and ground.
Does the voltage measure at the specified value?
| B+
| Go to
Step 4
| Go to
Step 5
|
4
| Use the DMM in order to measure the resistance between
terminal B of the windshield wiper motor connector and ground.
Does the resistance measure within the specified range?
| Less than 2 ohms
| Go to
Step 6
| Go to
Step 7
|
5
|
- Disconnect the windshield wiper/washer switch.
- Use the DMM in order to measure the voltage between terminal 4
of the windshield wiper/washer switch connector and ground
Does the voltage measure at the specified value?
| B+
| Go to
Step 9
| Go to
Step 10
|
6
|
- Inspect for a faulty connection at the windshield wiper motor
connector.
- If the connection is OK, replace the windshield wiper motor. Refer
to
Windshield Wiper Motor Replacement
.
Is the repair complete?
| --
| Go to
Step 11
| Go to
Step 8
|
7
|
- Locate an open or a high resistance in CKT F9.
- Repair the open or the high resistance in CKT F9.
Is the repair complete?
| --
| Go to
Step 11
| --
|
8
|
- Locate a short to ground in any of the following circuits.
• | WSW motor voltage LO circuits |
• | Motor voltage HI circuits |
• | Interval signal circuit |
- Repair the short to ground in these circuits.
Is the repair complete?
| --
| Go to
Step 11
| --
|
9
| Replace the windshield wiper/washer switch. Refer to
Windshield Wiper and Washer Switch Replacement - On Vehicle
in Steering.
Is the repair complete?
| --
| Go
to
Step 11
| --
|
10
|
- Locate an open or a high resistance in CKT FY11 or in CKT FY1.
- Repair the open or the high resistance in CKT FY11 or in
CKT FY1.
Is the repair complete?
| --
| Go
to
Step 11
| --
|
11
|
- Reconnect all of the connectors and the components that were disconnected.
- Verify that the windshield wipers operate properly at low speed.
Do the windshield wipers operate properly at High speed?
| --
| Go to
Wiper/Washer System Check
| Go to
Step 1
|