Step | Action | Values | Yes | No | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views Important: Before attempting to diagnose the inclination sensor, ensure that the Intrusion Sensor Step 1, and Step 2 is enabled in the Dash Integration Module (DIM) Set Options menu. DEFINITION: After arming, the content theft deterrent (CTD) system does not enter alarm mode when there is motion inside the vehicle. | ||||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |||||||||
2 | Were you sent here from Content Theft Deterrent (CTD) Alarm Mode Inoperative? | -- | Go to Step 3 | |||||||||
3 |
Does the test lamp illuminate? | -- | Go to Step 4 | Go to Step 8 | ||||||||
4 | With a DMM, measure the voltage of the intrusion sensor armed signal circuit at the intrusion sensor harness connector. Is the voltage near the specified value? | 12 V | Go to Step 5 | Go to Step 6 | ||||||||
5 | Test the intrusion sensor alarm on signal circuit for the following conditions:
Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 7 | ||||||||
6 | Test the intrusion sensor armed signal circuit for an open or a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 10 | ||||||||
7 | Inspect for a loose or poor connection at the harness connector of the intrusion sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 9 | ||||||||
8 | Repair the intrusion sensor battery positive voltage circuit. Refer to Wiring Repairs . Did you correct the condition? | -- | Go to Step 12 | -- | ||||||||
9 | Replace the intrusion sensor. Refer to Theft Deterrent Sensor Replacement . Did you correct the condition? | -- | Go to Step 12 | Go to Step 10 | ||||||||
10 | Inspect for a loose or poor connection at the harness connector of the rear integration module (RIM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 11 | ||||||||
11 | Replace the RIM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 12 | -- | ||||||||
12 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 | ||||||||
