Power Mirror Replacement Power

1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
2. Disconnect the power mirror wire harness electrical connector (3).
3. Remove the mirror fasteners (4, 5, 6).
4. Remove the mirror (1) from the door.
5. Pull the wiring harness through the hole in the mirror patch.

1. Route the mirror wiring harness through the hole in the mirror patch.
2. Seat the grommet (2) into the hole in the door frame.
3. Install the mirror (1) into the door frame.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the mirror fasteners in the following sequence:

Tighten

1. Tighten the top mirror fastener (4) to 9 N·m (80 lb in).
2. Tighten the forward mirror fastener (5) to 9 N·m (80 lb in).
3. Tighten the rear, lower mirror fastener (6) to 9 N·m (80 lb in).
5. Connect the power mirror electrical connector (3).
6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .

Power Mirror Replacement Power Folding

The power folding mirror motor is not serviceable. If the motor fails, the power folding mirror must be replaced as an assembly. The mirror face and the mirror face motor are serviceable. Refer to Outside Rearview Mirror Motor Replacement or Outside Rearview Mirror Glass Replacement.

1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
2. Disconnect the power mirror wire harness electrical connector (3).
3. Remove the mirror fasteners (4, 5, 6).
4. Remove the mirror (1) from the door.
5. Pull the wiring harness through the hole in the mirror patch.

1. Route the mirror wiring harness through the hole in the mirror patch.
2. Seat the grommet (2) into the hole in the door frame.
3. Install the mirror (1) into the door frame.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the mirror fasteners in the following sequence:

Tighten

1. Tighten the top mirror fastener (4) to 9 N·m (80 lb in).
2. Tighten the forward mirror fastener (5) to 9 N·m (80 lb in).
3. Tighten the rear, lower mirror fastener (6) to 9 N·m (80 lb in).
5. Connect the power mirror electrical connector (3).
6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .