Important: In order to maintain the proper component balance, contact surface taper, and heat transfer, manual transmission flywheels are NOT to be machined.
- Clean the flywheel in solvent.
Caution: Refer to Safety Glasses Caution in the Preface section.
- Dry the flywheel with compressed air.
- Inspect the manual transmission flywheel for loose or improperly installed balance weights.
A properly installed balance weight should be installed until flush or below flush with the face of the flywheel.
- Inspect the manual transmission flywheel for the following conditions:
| • | Grooved or scored surface (2) |
| • | Damaged ring gear teeth (4) |
| • | Loose or improperly positioned ring gear |
| • | The ring gear has an interference fit onto the flywheel and should be positioned completely against the flange of the flywheel. |
| • | Missing, bent, or damaged pressure plate locating pins |
| • | The 2 locating pins are installed into the flywheel and spaced 170 degrees apart to ensure proper orientation of the clutch pressure plate to the engine flywheel during
assembly. |
