Sunroof Motor/Actuator Replacement Smart Motor

1. Lower the headliner in order to access the sunroof motor/actuator. Refer to Headlining Trim Panel Replacement in Interior Trim.
2. Disconnect the electrical connector.
3. Remove the screws securing the sunroof motor/actuator to the module.

1. Install the sunroof motor/actuator to the sunroof module.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the sunroof motor/actuator screws.

Tighten
Tighten the screws to 6 N·m (53 lb in).

3. Connect the electrical connector.
4. Verify the sunroof operation.
5. Initilization /Teach the sunroof motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process .
6. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
7. Refer to Control Module References for programming and setup information.

Sunroof Motor/Actuator Replacement with Control Module

1. Lower the formed headliner in order to access the sunroof actuator. Refer to Headlining Trim Panel Replacement .

Important: If the sunroof window is partially closed, remove the actuator first before moving the sunroof window forward.

2. Cut the electrical tape (5) securing the electrical harness to the sunroof actuator.
3. Disconnect the electrical connectors (1,3) from the sunroof actuator (4).
4. Remove the screws (2) securing the sunroof actuator (4) to the sunroof module.
5. Remove the sunroof actuator.

1. Manually move the sunroof window to the full closed position.



2. Install the sunroof actuator (4) to the sunroof module.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the sunroof actuator screws (2).

Tighten
Tighten the screws to 5.8 N·m (51 lb in).

4. Connect the electrical connectors (1,3).
5. Apply new electrical tape (5) in order to secure the electrical harness to the sunroof actuator.
6. Verify the sunroof operation.
7. Install the formed headliner. Refer to Headlining Trim Panel Replacement .
8. Refer to Control Module References for programming and setup information.