Engine Flywheel Installation Automatic Transmission

Tools Required

1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.



3. Install the EN 46106 .

Notice: Refer to Fastener Notice in the Preface section.




4. Install the remaining NEW engine flywheel bolts.

Tighten

1. Tighten the NEW engine flywheel bolts to 30 N·m (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059 .



5. Remove the EN 46106 .

Engine Flywheel Installation Manual Transmission

Tools Required

1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.



3. Install the EN 46106 .

Notice: Refer to Fastener Notice in the Preface section.




4. Install the remaining NEW engine flywheel bolts.

Tighten

1. Tighten the NEW engine flywheel bolts to 30 N·m (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 75 degrees using the J 45059 .



5. Install the clutch driven plate disc and the clutch pressure plate to the engine flywheel. Ensure to align the clutch pressure plate to the pins in the engine flywheel.
6. Loosely install the clutch pressure plate bolts.



7. Install the J 33169 through the clutch driven plate disc and into the end of the crankshaft in order to align the clutch driven plate disc.
8. Tighten the clutch pressure plate bolts.

Tighten
Tighten the clutch pressure plate bolts to 23 N·m (17 lb ft).

9. Remove the J 33169 .