GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 CTS 🢒 Engine 🢒 Engine Mechanical - 2.8L (LP1) 🢒 Water Pump and Generator Belt Tensioner Replacement

Removal Procedure

    Object Number: 887773 Size: SH
  1. Remove the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement .
  2. Loosen the drive belt tensioner bolt.
  3. Remove the drive belt tensioner and bolt from the engine.

Installation Procedure

    Object Number: 887773 Size: SH
  1. Position the drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the drive belt tensioner bolt.

    4. Tighten
    Tighten the bolt to 50 N·m (37 lb ft).

  4. Install the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement .