Coolant Heater Replacement V6

1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Disconnect the coolant heater cord from the coolant heater.



4. Remove the coolant heater.

1. Install the coolant heater.
2. Connect the coolant heater cord to the coolant heater.
3. Lower the vehicle.

Coolant Heater Replacement LS6

1. Drain the cooling system. Refer to Cooling System Draining and Filling .
2. Remove the tire and wheel, if necessary. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Disconnect the engine coolant heater cord from the engine coolant heater.



4. Remove the engine coolant heater.

Important: Take care not to damage the surface of the opening in the engine block.

5. Clean the opening in the engine block, remove any burrs, sealing compound, or paint.

Important: The engine coolant heater sealing washer may be reused if not bent, scored or otherwise damaged.




1. Apply a 3.175 mm (0.125 in) bead of sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the engine coolant heater sealing washer.
2. Insert the engine coolant heater.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Tighten the engine coolant heater.

Tighten
Tighten the engine coolant heater to 40 N·m (30 lb ft).




4. Install the engine coolant heater cord to the engine coolant heater.
5. Install the tire and wheel, if necessary. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
6. Fill the cooling system. Refer to Cooling System Draining and Filling .