GM Service Manual Online
For 1990-2009 cars only

Tools Required

    • J 8037 Piston Ring Compressor
    • J 8087 Cylinder Bore Gage
    • J 41556 Connecting Rod Guide
    • J 45059 Angle Meter

Piston Selection


    Object Number: 188016  Size: SH

    Important: Measurements of all components should be taken with the components at normal room temperature. For proper piston fit, the engine block cylinder bores must not have excessive wear or taper. A used piston, pin, and connecting rod assembly may be installed if, after inspection is within specifications.

  1. With a micrometer at a right angle, measure the piston outside diameter (OD). Measure the diameter 43 mm (1.69 in) from the top of the piston. Refer to Engine Mechanical Specifications .
  2. Record the piston OD.

  3. Object Number: 4974  Size: SH
  4. Adjust the micrometer to the recorded piston OD.
  5. Insert the J 8087 into the micrometer and zero the gage dial.

  6. Object Number: 4972  Size: SH
  7. Using the J 8087 , measure the cylinder bore inside diameter (ID). Measure at a point 64 mm (2.5 in) from the top of the cylinder.
  8. Record the cylinder bore ID.
  9. Subtract the piston OD from the cylinder bore ID to determine the piston-to-bore clearance. Refer to Engine Mechanical Specifications .
  10. If the proper clearance cannot be obtained, select another piston, pin, and connecting rod assembly and again measure the clearances. If the proper fit cannot be obtained, the cylinder bore may require honing for an oversize piston.

Piston, Pin, and Connecting Rod Installation


    Object Number: 1366359  Size: SH
  1. Lightly lubricate the following components with clean engine oil:
  2. • Piston (1)
    • Piston rings
    • Cylinder bore
    • Bearings (3) and bearing surfaces
  3. Position the oil control ring end gaps a minimum of 25 mm (1.0 in) from each other.
  4. Position the compression ring end gaps 180 degrees opposite each other.

  5. Object Number: 1366358  Size: SH
  6. Install the J 41556 to the connecting rod.

  7. Object Number: 63217  Size: SH
  8. Install the J 8037 onto the piston and compress the piston rings.
  9. Important: The piston alignment mark MUST face the front of the engine block.

  10. Install the piston, pin, and connecting rod assembly into the cylinder bore. Hold the piston ring compressor firmly against the engine block. Using a wooden hammer handle, lightly tap the top of the piston until all the piston rings have entered the cylinder bore.

  11. Object Number: 63186  Size: SH
  12. Use the J 41556 to guide the connecting rod onto the crankshaft journal.
  13. Remove the J 41556 from the connecting rod.
  14. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 53223  Size: SH

    Important: The connecting rod and cap must be assembled with the mating surfaces properly aligned.

  15. Install the bearing cap, bearing half, and bolts.
  16. Tighten

    1. Tighten the bolts a first pass to 20 N·m (15 lb ft).
    2. Tighten the bolts a final pass to 85 degrees using the J 45059 .

    Object Number: 1366378  Size: SH
  17. Measure the connecting rods for the proper side clearance. Refer to Engine Mechanical Specifications .