GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.


    Object Number: 293245  Size: SH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Use the tilt lever to tilt the column to the UP position.

  4. Object Number: 293248  Size: SH

    Caution: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.

  5. Remove one end of the tilt spring (1) from the steering column support assembly (2) and the other end from the steering column tilt head assembly (3) by using the following procedure:
  6. 4.1. Pry up the tilt spring (1) until a bulge occurs and most of the tilt spring tension is removed.
    4.2. Secure the tilt spring (1) with locking pliers.
    4.3. Continue prying up the tilt spring (1) until the tilt spring disengages from the post on the steering column support assembly (2) and from the steering column tilt head assembly (3).

    Object Number: 293249  Size: SH
  7. Remove the spring guide (1) from the tilt spring (2).

Installation Procedure


    Object Number: 293245  Size: SH
  1. Use the tilt lever to tilt the column to the UP position.

  2. Object Number: 293249  Size: SH
  3. Install the spring guide (1) into the tilt spring (2).

  4. Object Number: 293251  Size: SH
  5. Install the tilt spring (1) onto the steering column support assembly (2) and onto the steering column tilt head assembly by using the following procedure:
  6. 3.1. Install the tilt spring (1) onto the steering column tilt head assembly.
    3.2. Install the tilt spring (1) onto the post on the steering column support assembly (2).
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.