For 1990-2009 cars only
Removal Procedure
- When replacing or repairing an emblem/nameplate do the following:
- To remove an emblem/nameplate, heat the emblem/nameplate using a heat gun. Apply heat using a circular motion for about 30 seconds.
- Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
- When replacing, remove all adhesive as follows:
| 1.1. | Use tape to protect the mounting surface during removal. |
| 1.2. | Use tape for alignment marks for installation of the emblem/nameplate. |
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
| • | For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent. |
| • | For plastic panels use a lint-free cloth and varnish makers and painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive. |
Installation Procedure
- Clean the area where the emblem/nameplate will be installed.
- Dry the area thoroughly.
- Apply tape and mark the location as shown.
- Heat the mounting surface to approximately 27-41°C (80-105°F).
- Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
- Remove the protective liner from the back of the emblem/nameplate.
- Position the emblem/nameplate to the alignment holes and press the emblem/nameplate to the mounting surface.
- Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
- Remove the protective tape from the mounting surface.
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
Use a lint free cloth and VMP naptha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.
