Schematic Reference: Instrument Cluster Schematics

Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Start the engine.

Does the tachometer operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn ON the ignition, with the engine OFF.
2. Install a scan tool.
3. With a scan tool, sweep the tachometer.

Does the tachometer move from 0 RPM to 7000 RPM and back to 0 RPM when you sweep this gage up and down?

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Go to Step 4

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3