Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
2. Remove the passenger front seat. Refer to Front Seat Replacement - Bucket in Seats.
3. Remove the passenger front carpet retainer. Roll back the carpet.
4. Remove the right side cowl trim panel. Refer to Cowl Side Trim Panel Replacement in Interior Trim.
5. Remove the right side insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages, and Console.

1

Connector, Inflatable Restraint Sensing and Diagnostic Module Electrical

Tip
Remove the connector position assurance (CPA).

2

Bolts, Inflatable Restraint Sensing and Diagnostic Module (Qty: 3)

Tighten
10 N·m (89 lb in)

3

Module, Inflatable Restraint Sensing and Diagnostic

Refer to Control Module References for programming and setup information.

Tip