Schematic Reference: Instrument Cluster Schematics

Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Press and release each of the driver information center (DIC) switches.
4. With a scan tool, observe the DIC Switch parameters in the instrument panel cluster (IPC) data list.

Does the scan tool display Active when each switch is pressed and Inactive when each switch is released?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Does the scan tool display Inactive when each switch is pressed?

Go to Step 9

Go to Step 4

Does the scan tool always display Active for the suspect switch even when the switch is released?

Go to Step 5

Go to Step 6

1. Turn OFF the ignition.
2. Disconnect the DIC switch connector.
3. Turn ON the ignition, with the engine OFF.
4. With a scan tool, observe the suspect DIC Switch parameter.

Does the scan tool display Active for the suspect switch?

Go to Step 7

Go to Step 12

1. Turn OFF the ignition.
2. Disconnect the DIC switch assembly connector.
3. Connect a 3-amp fused jumper wire between the signal circuit of the suspect DIC switch and a good ground. Refer to Circuit Testing .
4. Turn ON the ignition, with the engine OFF.
5. With a scan tool, observe the suspect DIC Switch parameter.

Does the scan tool display Active for the suspect switch?

Go to Step 10

Go to Step 8

Test the signal circuit of the suspect DIC switch for a short to ground. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 14

Go to Step 11

Test the signal circuit of the suspect DIC switch for an open or high resistance. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 14

Go to Step 11

Test the ground circuit of the DIC switch assembly for an open or high resistance. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 14

Go to Step 10

Inspect for poor connections at the harness connector of the DIC switch assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 14

Go to Step 12

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 14

Go to Step 13

Replace the DIC switch assembly. Refer to Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel .

Did you complete the replacement?

Go to Step 14

--

Replace the IPC. Refer to Control Module References for replacement, setup, and programming .

Did you complete the replacement?

Go to Step 14

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2