Callout | Component Name |
|---|---|
|
Caution: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction. Notice: Refer to Fastener Notice in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure
| |
1 | Handle, Seat Recliner Refer to Driver Seat and Passenger Seat Recliner Handle Replacement . |
2 | Plug, Seat Recliner Handle |
3 | Cover, Seat Outer Adjuster Refer to Front Seat Adjuster Track Finish Cover Replacement . |
4 | Cover, Seat Outer Adjuster Refer to Front Seat Adjuster Track Finish Cover Replacement . |
5 | Seat Back Assembly Refer to Front Seat Back Replacement . |
6 | Cover, Seat Cushion Refer to Front Seat Cushion Cover and Pad Replacement . |
7 | Pad Assembly, Seat Cushion Refer to Front Seat Cushion Cover and Pad Replacement . |
8 | Frame Assembly, Seat Cushion |
9 | Retainers, Inflatable Restraint Passenger Presence System Bladder (Qty: 2) |
10 | Bladder, Inflatable Restraint Passenger Presence System |
11 | Screws, Electronic Control Unit (Qty: 2) Tighten |
12 | Electronic Control Unit |
13 | Switch, Inflatable Restraint Passenger Presence System Pressure Refer to Control Module References for programming and setup information. Tip |
