Special Tools

1. Remove the right engine mount strut. Refer to Engine Mount Strut Replacement - Right Side .
2. Install the J-41803-9 to the right engine mount strut bracket (1).



3. Install the J 42451-1 to the left side engine lift bracket.



4. Install the J 42451-1 to the right rear engine lift bracket.
5. Open and secure the hood in a 90 degree position.



6. Install a J 28467-B and retention pin to each end of the J 43405  (2).



7. Position the J 28467-B to the left and right side inner fender rails in order to install the J 43405 .



8. Assemble the following to create 2 lift hook assemblies as shown:

•	J 28467-34

•	J 28467-6A

•	J 28467-7A




9. Install the 2 lift hook assemblies (1) to the J 45057-2  (2).



10. Install the right side lift hook assembly to the right side hole in the J-41803-9  (2).



11. Install the left side lift hook assembly to the left side hole in the J-41803-9  (2).
12. Gently tighten the J 28467-34 lift hook wing nuts.
13. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
14. Remove the lower air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors .
15. Install one end of a suitable utility strap to the transaxle.

•	If the vehicle is equipped with all wheel drive (AWD), carefully wrap the utility strap around the transfer case.

•	If the vehicle is equipped with front wheel drive (FWD), carefully wrap the utility strap around the transaxle case extension housing.

16. Install the opposite end of the utility strap to a suitable underbody structure.
17. Tighten the utility strap in order to prevent movement of the powertrain.