1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the knock sensor wiring harness electrical connector.
3. Remove the knock sensor.

Important:  DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors ability to detect detonation.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the knock sensor.

Tighten
Tighten the knock sensors to 25 N·m (18 lb ft).

2. Connect the knock sensor wiring harness electrical connector.
3. Lower the vehicle.