SERVICE MANUAL UPDATE REVISED POWER STEERING HOSE

REVISED POWER STEERING PRESSURE HOSE SERVICE SERVICE MANUAL UPDATE

VEHICLES AFFECTED: PROCEDURE- 1986-88 E SERIES -----------------

The following is a revised procedure for servicing the power steering inlet (pressure) hose on 1986 through 1988 'E' Series models (Section 3B1).

REMOVE or DISCONNECT

1. Negative battery cable

2. Serpentine drive belt

3. Inlet hose at pump

4. Raise vehicle, see section 0A of Chassis Service Manual

5. Heat shield

6. Hose retainer

7. Inlet hose at gear

8. Hose from vehicle

INSTALL or CONNECT

1. Hose into vehicle

2. Inlet hose at gear-tighten to 27 N m (20 ft. lbs)

3. Hose retainer

4. Heat shield

5. Lower vehicle

6. Inlet hose at pump-tighten to 27 N m (20 ft.lbs)

7. Serpentine belt

8. Fill with fluid

9. Negative battery cable

10. Bleed power steering system (use latest bleed procedure per bulletin)

11. Inspect for leaks

This revised procedure should be followed whenever it is necessary to service the power steering inlet (pressure) hose.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.