GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The electronic brake control module (EBCM) learns the model it is installed in, by using the vehicle ID information via the class 2 serial data line. Each time the vehicle is in the RUN position or the powertrain control module (PCM) communicates this information via class 2, the EBCM internally compares the VIN information with the information stored in digits 2 through 5 of the VIN. If digit 5 of the VIN is incorrect, the EBCM will indicate a VIN information error is present.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC C0565 Vehicle Identification Number (VIN) Information Error

Conditions for Setting the DTC

    • The EBCM detects digit 5 of the VIN is incorrect.
    • The condition must occur when the ignition switch is first turned on.

Action Taken When the DTC Sets

The EBCM stores DTC C0565 in memory.

Conditions for Clearing the DTC

    • The EBCM recognizes digit 5 of the VIN as valid information.
    • A history DTC will clear after 100 consecutive ignition cycles, if the condition for the malfunction is no longer present.

Diagnostic Aids

DTC C0565 is related to an internal VIN error in the EBCM. The VIN information is not removable from the EBCM.

Step

Action

Yes

No

Schematic Reference: Antilock Brake System Schematics

Connector End View Reference: Antilock Brake System Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

Are any other DTCs present besides C0565?

Go to Diagnostic Trouble Code (DTC) List - Vehicle

Go to Step 3

3

Replace the electronic brake control module (EBCM) with the correct module, and part number. Refer to Control Module References for replacement, setup, and programming.

Is the replacement complete?

Go to Step 4

--

4

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK