Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Wiper/Washer Connector End Views | |||
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Turn the ignition ON. Are the windshield washers always on? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
Disconnect the windshield wiper/washer switch connector at the multifunction switch assembly. Are the windshield washers always on? | Go to Step 4 | Go to Step 5 | |
4 | Repair the short to voltage in the windshield washer pump control circuit. Refer to Circuit Testing and Wiring Repairs . Did you complete the repair? | Go to Step 6 | -- |
5 | Replace the windshield wiper/washer switch. Refer to Turn Signal Multifunction Switch Replacement . Is the repair complete? | Go to Step 6 | -- |
6 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
