GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Rendezvous - FWD 🢒 Body Systems 🢒 Wipers and Washers 🢒 Windshield Wiper System Module Replacement

Removal Procedure

    Object Number: 697659 Size: SH
  1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
  3. Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement.
  4. Remove the cruise control module. Refer to Cruise Control Module Replacement.
  5. Disconnect the wiper motor cover electrical connector.
  6. Remove the wiper system drive module bolts.
  7. Remove the wiper system drive module from the engine compartment.

Installation Procedure

    Object Number: 697659 Size: SH
  1. Position the wiper system drive module to the cowl.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the wiper system drive module bolts.

    3. Tighten
    Tighten the bolts to 9 N·m (80 lb in).

  3. Connect the wiper motor cover electrical connector.
  4. Install the cruise control module and bracket. Refer to Cruise Control Module Replacement.
  5. Install the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement.
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
  7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .