Schematic Reference: Interior Lights Schematics

Connector End View Reference: Master Electrical Component List

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Turn the ignition switch to the RUN position.
2. Turn the door switch to the ON position.
3. Turn the headlamp switch to the HEAD position.

Do all of the illumination lamps illuminate?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Is only one lamp inoperative?

Go to Step 6

Go to Step 4

Test for a short to ground in the interior lamp defect switch signal circuit. Refer Circuit Testing and Wiring Repairs .

Did you find and complete the repair?

Go to Step 8

Go to Step 5

Inspect for a poor connection at the harness connectors of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and complete the repair?

Go to Step 8

Go to Step 7

Repair the open in the inoperative lamp voltage supply circuit or courtesy lamps control circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 8

--

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3